Ifconfig Show currently configured interfaces You can use the show access-control-config command to view the access control policy configuration.Īccess-control-config Show Current Access-Control Configurationĭisk-manager Display current status of local disk(s) Escape character sequence is 'CTRL-^X'.ĭisplaying the Access Control Policy Details Ip Configure Module logging port ip addressesĬonnected to module sfr. All rights reserved.Ĭisco is a registered trademark of Cisco Systems, Inc.Īll other trademarks are property of their respective owners.Ĭonsole Login to console port on another module. Warning: Permanently added '172.27.5.18' (RSA) to the list of known hosts.Ĭopyright 2004-2017, Cisco and/or its affiliates. These commands are also the same on the Firepower Threat Defense (FTD) device. Below are some useful Cisco FirePOWER Module troubleshooting commands via the command line interface (CLI). I am connecting my laptop to outside1 interface, the management and interface g0/0 are connected to the switch in the same vlan.You can directly SSH to the Cisco FirePOWER Module IP address or issue the session sfr console from the ASA privileged EXEC mode. Please tell me if the connections I have done has a mistake. The firewall is in transparent mode, the access-lists any any are configured. Internal-Data0/2 unassigned YES unset up up Internal-Data0/1 unassigned YES unset down down Internal-Data0/0 unassigned YES unset up up Internal-Control0/0 127.0.1.1 YES unset up up GigabitEthernet0/5 unassigned YES unset administratively down down GigabitEthernet0/4 unassigned YES unset administratively down down GigabitEthernet0/3 unassigned YES unset administratively down down GigabitEthernet0/2 unassigned YES unset administratively down down GigabitEthernet0/0 unassigned YES unset up up Interface IP-Address OK? Method Status Protocol Though both are IP addresses are in the same subnet, I am unable to ping them. The ASA's internal IP address is not able to reach the IP address of the SFR module. The sfr module is always in recover stage. IPv6 Configuration: Stateless autoconfiguration GigabitEthernet0/3 10.0.210.254 YES CONFIG up up #Interface IP-Address OK? Method Status Protocol Mod Status Data Plane Status Compatibility Ips Unknown No Image Present Not ApplicableĬxsc Unknown No Image Present Not Applicable Mod SSM Application Name Status SSM Application Version Mod MAC Address Range Hw Version Fw Version Sw Version So my question is whethere there is any problem on the module itself? So it would be nice to know where did I make the mistake? I did reload and recovery of the module and I see the status as still recovery state. ![]() So it doesn't has any dedicated interface for the firepower management. But unfortunately I cannot ping the gateway IP address which is basically the one of the interface of the firewall. ![]() So I have shutdown the management interface and configure the firepower management IP on the Server network. ![]() The firewall is at branch location and do not have any more router on the LAN network. Today I have been trying to configure the ASA firepower module's IP address.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |